FlexPro Forum – Discuss Your Topic!

Takes a long time to open

Home > Community > General > Takes a long time to open

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #12843
    Charles HertzCharles Hertz
    Participant

    Hi,

    I have to open a Flexpro template, however, it takes a lot of time to open it (about 1.30 sec). There are just two 100K points signals, few calculations.

    What can be the reason of this low speed?

    Thanks in advance.

    #8503
    Charles HertzCharles Hertz
    Participant

    Hi,

    I have to open a Flexpro template, however, it takes a lot of time to open it (about 1.30 sec). There are just two 100K points signals, few calculations.

    What can be the reason of this low speed?

    Thanks in advance.

    #9339
    Bernhard KantzBernhard Kantz
    Participant

    When loading a template database, it may depend on the storage location, how fast the operation will be finished. If one accesses e.g. a global template database over the network, there will be a greater delay than loading from a personal tamplate database typically hosted on a local drive.
    In the Online Help you may find additional informations on tuning the performance in the chapters Data Management > Project Database > Working with Project Databases > Optimizing FlexPro for Large Volumes of Data and … > Troubleshooting Project Databases.
    When using a specific project database a long time, the space used on the storage will increment even if one deletes a lot of datasets and other objects; using the defragmentation can shrink the size to the amount actually needed. The Online Help chapter Data Management > Project Database > Working with Project Databases > Defragmenting a Project Database describes the operation.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.