Takes a long time to open

[Charles Hertz]

Hi,

I have to open a Flexpro template, however, it takes a lot of time to open it (about 1.30 sec). There are just two 100K points signals, few calculations.

What can be the reason of this low speed?

Thanks in advance.

[Charles Hertz]

Hi,

I have to open a Flexpro template, however, it takes a lot of time to open it (about 1.30 sec). There are just two 100K points signals, few calculations.

What can be the reason of this low speed?

Thanks in advance.

[Bernhard Kantz]

When loading a template database, it may depend on the storage location, how fast the operation will be finished. If one accesses e.g. a global template database over the network, there will be a greater delay than loading from a personal tamplate database typically hosted on a local drive.
In the Online Help you may find additional informations on tuning the performance in the chapters [b]Data Management > Project Database > Working with Project Databases > Optimizing FlexPro for Large Volumes of Data[/b] and [b]… > Troubleshooting Project Databases[/b].
When using a specific project database a long time, the space used on the storage will increment even if one deletes a lot of datasets and other objects; using the defragmentation can shrink the size to the amount actually needed. The Online Help chapter [b]Data Management > Project Database > Working with Project Databases > Defragmenting a Project Database[/b] describes the operation.

[Autor]

Beiträge