Forum FlexPro – Discuss your topic!

Flexpro 8 switch cursor button?

Accueil > Community > General > Flexpro 8 switch cursor button?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #12586
    Richard SmithRichard Smith
    Participant

    I am trialing the new Flexpro 8 but can’t seem to find how to do a basic task. I can’t switch cursors to another curve. In V7 there is the switch cursor to next curve button (as per attachment) but i can’t find this in V8?

    What am I missing?

    Thanks.

    #8249
    Richard SmithRichard Smith
    Participant

    I am trialing the new Flexpro 8 but can’t seem to find how to do a basic task. I can’t switch cursors to another curve. In V7 there is the switch cursor to next curve button (as per attachment) but i can’t find this in V8?

    What am I missing?

    Thanks.

    #8940
    Bernhard KantzBernhard Kantz
    Participant

    Open the submenu Navigation on the Cursors toolbar or the Cursors menu and choose the command Cursor to Front (Page down) or Cursor to Rear (Page up).
    We’ve renamed these commands because you can also use these commands in a 3D contour diagram.

    support@weisang.com

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.