FlexPro Forum – Discuss Your Topic!

Transfert function

Home > Community > General > Transfert function

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 3, 2009 at 1:43 am #12577
    mathias andriamisainamathias andriamisaina
    Member

    Hi,

    I would like to trace the bode diagram (amplitude and phase) after calculating transfert function between an input and an output signal.

    How can I do that with flexpro 8 ?

    Thx for help

    NNRZ

    November 3, 2009 at 1:43 am #8240
    mathias andriamisainamathias andriamisaina
    Member

    Hi,

    I would like to trace the bode diagram (amplitude and phase) after calculating transfert function between an input and an output signal.

    How can I do that with flexpro 8 ?

    Thx for help

    NNRZ

    November 3, 2009 at 6:20 pm #8930
    Bernhard KantzBernhard Kantz
    Participant

    You can calculate the phase response and the amplitude response with the Fourier Cross Spectral Analyis Object (Spectral Analysis Option). Select your input and output signal in the object list and choose New|Spectral Analysis|Cross Spectrum. Choose the Spectral Procedure Transfer Function and the Spectrum Type Amplitude or Phase. After that you could create a 2D-Diagramm with the amplitude response and the phase response.

    support@weisang.com

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.